Page 88 - Carboloy Catalogue - English

Basic HTML Version

milling cutters
milling inserts
turning holders
turning inserts
techNICAL info
90
Main application
Other applications
Conditional applications
Chipbreaker
Clamping designation
S
Workpiece material group
Description Aplied to inserts:
ccgt , dcgt , tcgt , vcgt
Turning
P
M
K
N
S
H
AL
Finishing
- high positive turning geometry with the sharp cutting edge
- from fine turning up to roughing of AL and AL alloys
- the main area of application – machined materials groups N
- continuous cut
Medium
Profile of cutting edge
Roughing
Range of cutting conditions:
f
z
0,05 ÷ 0,60 [mm.rev
-1
]
a
p
0,2 ÷ 7,0 [mm]
CHIPBREAKER – POSITIVE INSERTS
Chipbreaker
Clamping designation
S
Workpiece material group
Description Aplied to inserts:
CCMT, SCMT, TCMT, VCMT, WCMT
Turning
P
M
K
N
S
H
MU
Finishing
- for finishing and semi-roughing
- the main area of application – machined materials groups P, M and K
- continuous and interrupted cut
Medium
Profile of cutting edge
Roughing
Range of cutting conditions:
f
z
0,10 ÷ 0,60 [mm.rev
-1
]
a
p
0,8 ÷ 8,0 [mm]
Chipbreaker
Clamping designation
S
Workpiece material group
Description Aplied to inserts:
DCMT, SCMT, TCMT, WCMT
Turning
P
M
K
N
S
H
FU
Finishing
- fine turning and finishing
- the main area of application – machined materials groups P and K
- further area of application – machined materials group M
- continuous cut
Medium
Profile of cutting edge
Roughing
Range of cutting conditions:
f
z
0,08 ÷ 0,25 [mm.rev
-1
]
a
p
0,5 ÷ 3,0 [mm]
turning
Cutting data recommendations
Cutting data presented in this catalogue shall be seen as starting values. Cutting data might need to be adjusted due to conditions in the
application. Cutting data are influenced by several parameter i.e. hardness and heat treatment of material, surface conditions (cast/forging
skin or not) component design and the stability of setup. In good conditions the cutting data in the higher range can be used and under bad
conditions the cutting data should be on the lower side.