Page 89 - Carboloy Catalogue - English

Basic HTML Version

milling cutters
milling inserts
turning holders
turning inserts
techNICAL info
91
Chipbreaker
Clamping designation
X
Workpiece material group
Description Aplied to inserts:
NPG
Turning
P
M
K
N
S
H
FU
Finishing
- high universal cutting geometry characterized by low cutting resistance
- parting and grooving
- the main area of application – machined materials groups P and K
- further area of application - machined materials M
- the main area of application – machined materials groups S and H
- also continuous cut
Medium
Profile of cutting edge
Roughing
Range of cutting conditions:
f
z
0,08 ÷ 0,22 [mm.rev
-1
]
a
p
-
Chipbreaker
Clamping designation
X
Workpiece material group
Description Aplied to inserts:
NPG
Turning
P
M
K
N
S
H
MU
Finishing
- high universal cutting geometry characterized by very low cutting resistance
- parting and grooving
- the main area of application – machined materials groups P and M
- further area of application - machined materials K and S
- the main area of application – machined materials groups N and H
- also for moderate interrupted cut
Medium
Profile of cutting edge
Roughing
Range of cutting conditions:
f
z
0,08 ÷ 0,25 [mm.rev
-1
]
a
p
-
CHIPBREAKER – PARTING AND GROOVING INSERTS
Main application
Other applications
Conditional applications
turning
Cutting data recommendations
Cutting data presented in this catalogue shall be seen as starting values. Cutting data might need to be adjusted due to conditions in the
application. Cutting data are influenced by several parameter i.e. hardness and heat treatment of material, surface conditions (cast/forging
skin or not) component design and the stability of setup. In good conditions the cutting data in the higher range can be used and under bad
conditions the cutting data should be on the lower side.